SSANGYONG RODIUS 2004.09 Manual page 417

03-4
3010-01
1. OVERVIEW
(1) Driving Elements
The driving elements consist of two flat surfaces machined to a smooth finish.
One of these is the rear face of the engine flywheel and the other is the clutch cover pressure
plate. The clutch pressure plate is fitted into a clutch steel cover, which is bolted to the flywheel.
(2) Driven Elements
The driven element is the clutch disc with a splined hub which is free to slide lengthwise along
the splines of the input shaft.
The driving and driven elements are held in contact by spring pressure. This pressure is
exerted by a diaphragm spring in the clutch cover pressure plate assembly.
(3) Operating Elements
The clutch control system consists of the clutch pedal, clutch master cylinder, concentric slave
cylinder.
This system directly releases the clutch by using hydraulic pressure while the conventional
clutch system releases the clutch by using release lever and release fork.
This system provides higher efficiency than conventional clutch system, and its durability is
superior.
Adaptor (mounted on transmission case)
Concentric slave cylinder pipe (mounted inside of transmission)
Concentric slave cylinder (mounted inside of transmission)
Concentric slave cylinder pipe
Clutch assembly
CLUTCH
RODIUS 2004.09
Concentric slave cylinder
Adaptor