Drive Set Up Group; Table 19 Drive Set Up Group Parameters - Honeywell HercuLine 10260S Installation, Operation And Maintenance Manual

4. Set Up and Calibration Procedures - Drive Set Up Group

Drive Set Up Group

Table 19 lists the parameters and selections available for the SET DRVINF group.
Lower Display
Prompt
VERSON
SPEED
(90° @ 60hz)
SPEED
(90° @ 50hz)
POWER
TAG
ROTATE
TORQUE
50 10260S HercuLine® Actuator Installation, Operation and Maintenance Manual

Table 19 Drive Set Up Group Parameters

Upper Display
Selections or
Range of Setting
Nnnn FIRMWARE VERSION—Read Only. Displays the firmware
version currently in use by the actuator's CPU.
10s STROKE SPEED—Read Only. The speed is the number of
20s seconds it takes for the actuator shaft to move its full range
40s of travel.
60s
20s
40s
60s
40s
60s
12s STROKE SPEED—Read Only. The speed is the number of
24s
seconds it takes for the actuator shaft to move its full range
48s of travel.
72s
24s
48s
72s
48s
72s
POWER INPUT VOLTAGE AND FREQUENCY—Read
Only. Selects the power input voltage and line frequency of
the actuator.
1206 1206—120Volts, 60Hz
1205 1205—120Volts, 50Hz
2206 2206—220Volts, 60Hz
2205 2205—220Volts, 50Hz
Nnnnnn TAG NAME—Selects the tag name or identifier of the
actuator. Up to 6 alphanumeric characters. See "Set Tag
Name" on next page.
ROTATION— Indicates the factory calibrated degrees of
rotation.
90 90— Factory calibrated for 90 degrees of rotation.
10 lb-ft / 15 N-M Motor Torque value
20 lb-ft / 27 N-M
40 lb-ft / 55 N-M
60 lb-ft / 80 N-M
40 lb-ft / 55 N-M
80 lb-ft / 110 N-M
150 lb-ft / 200 N-M
200 lb-ft / 270 N-M
300 lb-ft / 400 N-M
Parameter Definition
Revision 5
7/07