Honeywell HercuLine 10260S Installation, Operation And Maintenance Manual page 61

Lower Display
Prompt
MFGDAT
LREP
LCAL
REPTYP
* NOTE: Date format is set by the UNITS parameter. See SET DISPLA set up group.
Revision 5 10260S HercuLine® Actuator Installation, Operation and Maintenance Manual
7/07
Upper Display
Selections or
Range of Setting
mmddyy * MANUFACTURING DATE—Read Only. Displays datecode
or of manufacture for actuator.
ddmmyy
mmddyy * DATE OF LAST REPAIR—Factory set only. Displays date
or of last repair.
ddmmyy
mmddyy * DATE OF LAST FACTORY CALIBRATION—Factory set
or only. Displays date of last factory calibration
ddmmyy
REPAIR TYPE—Factory set only. Displays a repair code to
identify the type of repair service previously performed.
NONE None
01 Future
02 Non-contact Sensor
03 Main CPU PWA repair
04 Motor service
05 Power Distribution PWA service
06 Switch repair
07 Relay service
08 Gear service
09 Service to repair water damage
10 Service to repair damage caused by heat
11 Service to repair due to over-voltage damage
12 Actuator reconfigured
13 Warranty Repair
4. Set Up and Calibration Procedures - Drive Set Up Group
Parameter Definition
51