Table of Contents
Advertisement
CAL POSOUT Group
The CAL POSOUT group is used to verify that the position sensor is operating and adjusted properly. This
group allows the local display to indicate the output voltage of the position sensor PWA. This display is
used when verifying that the sensor is operating and that it is properly calibrated. Table 21 shows the
selections available for the CAL POSOUT group.
Lower Display
Prompt
CALPOS
To access the display...
Auto - Manual Drive Switch
The Auto - Manual switch is located on the side of the actuator case below the handwheel. The switch
allows manual mode control of the actuator motor for set up, calibration and troubleshooting. Figure 16
shows an illustration of the Auto - Manual switch and Table 22 describes the switch settings. The Auto -
Manual Drive switch setting overrides all input signals (analog signal and remote setpoint) and local
display mode settings.
Revision 5
10260S HercuLine® Actuator Installation, Operation and Maintenance Manual
7/07
4. Set Up and Calibration Procedures - CAL POSOUT Group
Table 21 CAL POSOUT Group Parameters
Upper Display
Selections or
Range of Setting
n.nnn *
POSITION SENSOR OUTPUT—Read Only. Displays the
output voltage of the position sensor PWA
Press
SETUP
Upper Display =
until you see
Lower Display =
FUNCTION
Upper Display =
Lower Display =
Upper Display =
or
key
Lower Display =
FUNCTION
Upper Display =
Lower Display =
Parameter Definition
Result
CAL
POSOUT
DIS
CALPOS
BEGN
CALPOS
n.nnn
(Sensor output in volts)
POSOUT
55
Advertisement
Table of Contents
Troubleshooting
