Table 6 Set Up Groups - Honeywell HercuLine 10260S Installation, Operation And Maintenance Manual

Set Up Group Title
SET
INPUT
SET
RELAYn
n = 1, 2, 3, or 4
SET
CUROUT
SET
COMM
SET
DIGINP
SET
DISPLA
CAL
INPUT
CAL
MOTOR
CAL
CURENT
SET
LOCK
READ
STATUS
SET
DRVINF
SET
MAINT
CAL
POSOUT
Revision 5 10260S HercuLine® Actuator Installation, Operation and Maintenance Manual
7/07

Table 6 Set Up Groups

Pressing the FUNCTION Key Allows You to...
Select and set various parameters associated with the
input signal to the actuator.
Select relay functions. NOTE: Set Relay groups will
show on display only if relays are installed in the
actuator.
Select the output signal type of the actuator.
NOTE: Set Curout will show on display only if the
option was ordered.
Select communication parameters for remote control of
actuator when connected to a SCADA system.
Select the parameters for external digital input states.
Select and set parameters for the local display.
Calibrate input zero and span values.
Calibrate zero and span values for motor operation.
Calibrate actuator output.
Set or change security password. Enable or disable
security access to set up parameters and calibration
set up.
Display operating and alarm status. Display self-test
diagnostic results.
Display and/or set various parameters specific to the
actuator.
Display various operating statistics. Reset / Save
accumulated operating statistics
Use the display as an indicator, (in this case a
voltmeter) so you can verify the position sensor is
operating properly.
4. Set Up and Calibration Procedures - Set Up Groups
For Details, See
Table 8
Table 12
Table 13
Table 14
Table 15
Table 16
Calibration
Procedure,
Table 23
Calibration
Procedure,
Table 24
Calibration
Procedure,
Table 25
Table 17
Table 18
Table 19
Table 20
Table 21
31