Use - RGBlink VSP 628PRO User Manual

Chapter 4: Controlling Your Processor Remotely
Finally, select Ethernet or USB connect, click "Ok", and finish connecting.
The green square in the bottom right means the connection is successful, white red is not.

4.1.2 Use

Image Toolbar
Show the image information, including resolution, channel, position, size and the signal.
The image size will be changed when set the parameters.
Signal Select
Click the signal icon, and the output image will be switched to the selected signal.
Scale
Select Channel A or Channel B, and scale the image by adjusting X, Y, Width and Height
according to actual need. Click "Set" after finish.
Mode
Click "Mode", and enter to the interface as below. VSP 628PRO supports Std mode, PIP
Mode, Dual 2K Mode, Switcher Mode and Split Mode. User should select Std Mode before
choose PIP Mode, or it will not be shown on the interface.
Output
Click "Output", and enter to the interface as below if select Std mode, PIP Mode and
Switcher Mode.
VSP 628PRO User Manual 44