RGBlink VSP 628PRO User Manual page 37

After setting, turn the rotary knob and select <Connect Type> according to actual
connection mode. VSP 628PRO support 8 kinds of connection modes, they are
, , ,
Save to receiver after choose the connection mode, observe the display screen and
make sure if display image is correct. If wrong, change the connection types. Then
connect the Port D or Port U of One Sending Card to LED Screen is finished.
(9) The setting for port D is same as the above setting.
Rendering is as follows:
2. Connect the Port D and Port U of One Sending Card to LED Screen
(1) First, make sure the device is in normal operation.
(2) Select the input source, for example, DVI.
(3) Connect one cable to Port D, the other one to U.
(4) Connect Port U to LED screen, the settings are same as Step 4 to Step 8 of "Connect
the Port D or Port U of One Sending Card to LED Screen".
(5) Connect Port D to LED screen, the settings are as follows:
a. Turn the rotary knob, and select <Display Setup>:
VSP 628PRO
, , and
Height
Port Offset X
Port Offset Y
->Connect Type
Chapter 3: Using Your Product
respectively.
120
>>
User Manual
0
0
,
36