RGBlink VSP 628PRO User Manual page 84

Note: Above instructions are only for input optional module. For VSP 628PRO, if user
would install the output optional module, first, take apart the top panel, and unscrew the 3
fixed screws on sending card board to remove it (Figure 6).
Then unscrew the 2 fixed screws on output optional module, and pull out the output
module block (Figure 7).
Finally, push the output module into the output module slot, the install steps are the same
as step 4 to step 6 in "Install the Optional Module" part.
Note: There is the case that some customers connect the power cord of the sending
card to the F optional module, shown as Figure 8. This is not allowed to happen, or
the F optional module will be damaged.
VSP 628PRO
(Figure 5)
(Figure 6)
(Figure 7)
User Manual
Chapter 7: Appendix
83