AudioCodes E-SBC User Manual page 280

CHAPTER 16 Services
●
●
The following procedure describes how to configure Time Bands per Cost Group through the Web
interface. You can also configure it through ini file [CostGroupTimebands] or CLI (configure
voip > sip-definition least-cost-routing cost-group-time-bands).
➢
To configure a Time Band per Cost Group:
1. Open the Cost Groups table (Setup menu > Signaling & Media tab > SIP Definitions folder
> Least Cost Routing > Cost Groups).
2. Select a Cost Group for which you want to assign Time Bands, and then click the Time Band
link located below the table; the Time Band table for the selected Cost Group appears.
3. Click New; the following dialog box appears:
4. Configure a Time Band according to the parameters described in the table below.
5. Click Apply, and then save your settings to flash memory.
Parameter
'Index'
timeband-index
[CostGroupTimebands_
TimebandIndex]
'Start Time'
start-time
[CostGroupTimebands_
StartTime]
You cannot configure overlapping Time Bands.
If a Time Band is not configured for a specific day and time range, the default
connection cost and default minute cost configured for the Cost Group in the Cost
Groups table is applied.
Table 16-17:Time Band Table Description
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines the day and time of day from when this time band is
applicable. The format is DDD:hh:mm, where:
■ DDD is the day of the week, represented by the first three
letters of the day in upper case (i.e., SUN, MON, TUE, WED,
THU, FRI, or SAT).
■ hh and mm denote the time of day, where hh is the hour (00-23)
and mm the minutes (00-59)
For example, SAT:22:00 denotes Saturday at 10 pm.
Mediant 1000 Gateway & E-SBC | User's Manual
Description
- 242 -