AudioCodes E-SBC User Manual page 134

CHAPTER 13 Network
3. Configure an Ethernet Device according to the parameters described in the table below.
4. Click Apply.
Table 13-4: Ethernet Devices Table Parameter Descriptions
Parameter
'Index'
[DeviceTable_
Index]
'Name'
name
[DeviceTable_
DeviceName]
'VLAN ID'
vlan-id
[DeviceTable_
VlanID]
'Underlying
Interface'
underlying-if
[DeviceTable_
UnderlyingInterface]
'Tagging'
tagging
[DeviceTable_
Tagging]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines a name for the Ethernet Device. The name is used to
associate the Ethernet Device with an IP network interface in the IP
Interfaces table ('Underlying Device' field - see
Interfaces) and/or with a static route in the Static Routes table
('Ethernet Output Device' field - see
Defines a VLAN ID for the Ethernet Device.
The valid value is 1 to 3999. The default is 1.
Note: Each Ethernet Device must be configured with a unique VLAN
ID.
Assigns an Ethernet Group to the Ethernet Device. To configure
Ethernet Groups, see Configuring Ethernet Port
Note: The parameter is mandatory.
Defines VLAN tagging for the Ethernet Device.
■ [0] Untagged = (Default for pre-configured Ethernet Device) The
Ethernet Device accepts untagged packets and packets with the
same VLAN ID as the Ethernet Device. Incoming untagged
packets are assigned the VLAN ID of the Ethernet Device. The
Ethernet Device sends these VLAN packets untagged (i.e.,
removes the VLAN ID).
- 96 -
Mediant 1000 Gateway & E-SBC | User's Manual
Description
Configuring IP Network
Configuring Static IP
Groups.
Routing).