Typographical Conventions; Getting Familiar With Configuration Concepts And Terminology; Sbc Application - AudioCodes E-SBC User Manual

CHAPTER 1 Introduction

Typographical Conventions

This document uses the following typographical conventions to convey information:
Convention
Text enclosed by a
single apostrophe
'...'
Boldface font
Text enclosed by
double
apostrophes "..."
Courier font
Text enclosed by
square brackets
[...]
Getting Familiar with Configuration Concepts and
Terminology
Before using your device, it is recommended that you familiarize yourself with the basic
configuration concepts and terminology. An understanding of the basic concepts and terminology
will help you configure and manage your device more effectively and easily.

SBC Application

The objective of your configuration is to enable the device to forward calls between telephony
endpoints in the SIP-based Voice-over-IP (VoIP) network. The endpoints (SIP entities) can be
servers such as SIP proxy servers and IP PBXs, or end users such as IP phones. In the SIP world,
the endpoints are referred to as SIP user agents (UA). The UA that initiates the call is referred to as
the user agent client (UAC); the UA that accepts the call is referred to as the user-agent server
(UAS).
Table 1-1: Typographical Conventions
Description
Indicates Web interface parameters.
Indicates one of the following Web-based
management interface elements:
■ A button
■ A selectable value
■ The navigational path to a Web page
Indicates values that you need to enter
(type) in the Web interface.
Indicates CLI commands or ini-based file
configuration.
Indicates ini file parameters and values.
Indicates a note bulletin providing important
or useful information.
Indicates a warning bulletin alerting you to
potentially serious problems if a specific
action is not taken.
- 2 -
Mediant 1000 Gateway & E-SBC | User's Manual
From the 'Debug Level'
drop-down list, select
Basic.
Click the Add button.
In the 'IP Address' field,
enter "10.10.1.1".
At the CLI prompt, type
the following:
# configure system
Configure the
[GWDebugLevel]
parameter to [1].
-
-
Example