Configuring Additional Management Interfaces - AudioCodes E-SBC User Manual

CHAPTER 6 Web-Based Management

Configuring Additional Management Interfaces

The Additional Management Interfaces table lets you configure up to 16 management interfaces, in
addition to the OAMP management interface configured in the IP Interfaces table. Multiple
management interfaces lets you remotely access the device's management interfaces (see note
below) through different IP addresses. Each additional management interface can be configured to
use a specific network interface (Control and/or Media type) and TLS Context, and can be
configured to restrict access through HTTPS only.
●
●
The following procedure describes how to configure additional management interfaces through the
Web interface. You can also configure it through ini file [AdditionalManagementInterfaces] or CLI
(configure system > additional-mgmt-if).
➢
To configure additional management interfaces:
1. Open the Additional Management Interfaces table (Setup menu > Administration tab > Web
& CLI folder > Additional Management Interfaces).
2. Click New; the following dialog box is displayed:
3. Configure an additional management interface according to the parameters described in the
table below.
4. Click Apply, and then save your settings to flash memory.
Table 6-5: Additional Management Interfaces Table Parameter Descriptions
General
'Index'
[AdditionalManagementInterfaces_
Index]
'Interface Name'
interface-name
[AdditionalManagementInterfaces_
InterfaceName]
To allow access to the device's management interfaces through all network
interfaces configured in the IP Interfaces table, see the EnableWe-
bAccessFromAllInterfaces parameter. This parameter does not specify a TLS
Context nor a connectivity protocol (HTTP or HTTPS).
The feature is applicable only to the device's Web- and REST-based management
interfaces.
Parameter
Mediant 1000 Gateway & E-SBC | User's Manual
Description
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Assigns an IP network interface (from the IP Interfaces
table) to the management interface.
For more information on IP network interfaces, see
Configuring IP Network Interfaces.
Note:
- 41 -