Open Solution Network (Osn) Server; Configuring Native Vlan For Osn Server - AudioCodes E-SBC User Manual

CHAPTER 13 Network
Parameter
'Transport Type'
transport-type
[Srv2Ip_
TransportType]
1st/2nd/3rd Entry
'DNS Name (1-3)'
dns-name-1|2|3
[Srv2Ip_Dns1/2/3]
'Priority (1-3)'
priority-1|2|3
[Srv2Ip_
Priority1/2/3]
'Weight (1-3)'
weight-1|2|3
[Srv2Ip_
Weight1/2/3]
'Port (1-3)'
port-1|2|3
[Srv2Ip_Port1/2/3]

Open Solution Network (OSN) Server

This section describes various networking settings for the OSN server.
●
●

Configuring Native VLAN for OSN Server

You can configure a VLAN ID associated with any application type (Media, Control, or OAMP) to
access the Open Solution Network (OSN) server through the device's internal port switch. By
default, access to the OSN is from the OAMP interface VLAN ID 1. Configuring a Native VLAN is
useful, for example, to separate traffic within the device - between the OSN (i.e., application traffic)
and voice traffic.
This feature is applicable only if you connect to the OSN through one of the device's VoIP LAN
ports (on the front panel). If you are connecting to the OSN through the OSN's Gigabit Ethernet port
(on the rear panel), this feature is not applicable.
Defines the transport type.
■ [0] UDP (default)
■ [1] TCP
■ [2] TLS
Defines the first, second or third DNS A-Record to which the hostname
is translated.
By default, no value is defined.
Defines the priority of the target host. A lower value means that it is
more preferred.
By default, no value is defined.
Defines a relative weight for records with the same priority.
By default, no value is defined.
Defines the TCP or UDP port on which the service is to be found.
By default, no value is defined.
The OSN is a customer-ordered item.
For information on cabling the OSN, refer to the device's Hardware Installation
Manual.
Mediant 1000 Gateway & E-SBC | User's Manual
Description
- 121 -