Braking system
•
Disconnect the flexible bleeder pipes and re-tighten the bleeder screws, applying the correct
torque
Disc Inspection
FRONT
CAUTION
THE FRONT BRAKE DISC SHAPE DOES NOT CHANGE THE OPERATING AND MAINTENANCE
SPECIFICATIONS OF THE SYSTEM.
•
The following operations must be car-
ried out with the brake discs fitted on
the wheel; they refer to a single disc,
but are valid for both.
•
Check the disc for wear by measuring
the minimum thickness with a micro-
meter in different points. If the mini-
mum thickness, even in a single point
of the disc, is less than the minimum
value, replace the disc.
Disc thickness minimum value: 4 mm (0.16 in)
•
Using a dial gauge, check that the max-
imum oscillation of the disc does not
exceed the tolerance; otherwise, re-
place it.
Disc oscillation tolerance: 0.15 mm (0.0059 in),
with respect to the wheel centre line.
Removal
The following procedure is described for a single
calliper, but is valid for both front brake callipers.
•
Unscrew and remove the screws (1)
BRAK SYS - 176
V85 TT