Braking system
•
Repeatedly quickly pull and release
the rear brake lever, then keep it fully
pulled.
•
Loosen the bleed valve by a 1/4 turn so
that the brake fluid flows into the con-
tainer, this will release the tension on
the brake lever, risking making it arrive
at the end stop.
•
Close the bleed valve before arriving at
the end of the stroke with the lever.
•
Repeat the operation until the are no
air bubbles in the fluid going into the
container.
NOTE
WHEN BLEEDING THE HYDRAULIC SYSTEM, FILL THE
TANK WITH BRAKE FLUID WHEN NECESSARY CHECK
THAT DURING THE OPERATION THERE IS ALWAYS
BRAKE FLUID.
•
Screw the bleeding valve and remove
the pipe.
•
Top-up the reservoir until the correct
brake fluid level is obtained.
•
Refit and lock the rear brake oil reser-
voir cap.
•
Refit the rubber protection cover.
Removal
•
Undo and remove the joint screw (1)
from the front brake master cylinder af-
ter placing a suitable container under-
neath to collect the brake fluid
BRAK SYS - 186
V85 TT