MOTO GUZZI V85 TT Service Station Manual page 175

V85 TT
•
Remove the front brake calliper (3)
Installing
•
Remove the front brake calliper
•
Correctly position the new front brake
calliper (1) on the brake disc
•
Insert and tighten the screws (2)
•
Position the brake line on the brake
calliper and insert and tighten the
screw (3)
•
Remove the clamp from the front brake lever.
•
Remove the brake fluid reservoir cap and fill it with new brake fluid
CAUTION
PERFORM THE STANDARD BRAKING SYSTEM BLEEDING PROCEDURE, AS DESCRIBED AT
THE END OF THE CHAPTER.
•
Top up the fluid reservoir and refit the cap
•
Check the stroke and sensitivity of the brake lever
•
If the brake lever stroke is too long after carrying out the bleeding procedure, check the
braking system for leaks and, if none are found, bleed the system using the diagnostic in-
strument, as described
Braking system
BRAK SYS - 175