MOTO GUZZI V85 TT Service Station Manual page 169

V85 TT
•
Remove the support bracket (3)
•
Disconnect the connector (4)
•
Unscrew and remove the screws (5)
•
Remove the ABS control unit (6)
NOTE
FIRST OF ALL, DISCONNECT THE LINES BETWEEN THE
ABS CONTROL UNIT AND THE BRAKE MASTER CYLIN-
DERS AND SEAL THE OPEN COUPLINGS ON THE ABS
CONTROL UNIT IMMEDIATELY USING PROTECTIVE
PLUGS. NEXT, REMOVE THE LINES BETWEEN THE ABS
CONTROL UNIT AND THE BRAKE CALLIPERS AND SEAL
THESE COUPLINGS USING PROTECTIVE PLUGS TOO.
INSTALLATION
•
Remove the ABS modulator
•
Install the new completely pre-filled ABS control unit
•
In order to ensure that the brake fluid remains inside the ABS control unit, first remove the
protective plugs from the braking circuit couplings and connect the corresponding lines.
•
Once all the braking circuit lines have been connected, remove the protective plugs from
the couplings of the brake master cylinders and connect the respective lines to the ABS
control unit.
•
Remove the clamp from the front brake lever and the rear brake pedal
•
Remove the caps from the reservoirs and fill them with new brake fluid
CAUTION
PERFORM THE STANDARD BRAKING SYSTEM BLEEDING PROCEDURE, AS DESCRIBED AT
THE END OF THE CHAPTER.
Braking system
BRAK SYS - 169