Braking system
•
Fill the reservoirs and refit the caps
•
Check the stroke and sensitivity of the front brake lever and the rear brake pedal
•
If the brake pedal or lever stroke is too long after carrying out the bleeding procedure, check
the braking system for leaks and, if none are found, bleed the system using the diagnostic
tool, as described.
•
Disconnect the flexible bleeder pipes and re-tighten the bleeder screws, applying the correct
torque
ABS CONTROL UNIT CONNECTOR INSERTION PROCEDURE
•
Check the initial position of the connection clip lever.
•
When the connector is fully inserted,
the distance between the connector
and the ABS control unit must be 7.5
mm (0.29 in).
•
If the initial position of the connector
and the driving lever is not that shown
in fig. 1, the connector will not be prop-
erly coupled and the distance meas-
ured will be greater (12 mm approx.
(0.47 in)). In this case repeat the oper-
ation as described in the two previous
points.
IT IS ADVISABLE TO CREATE A TEMPLATE
TO CHECK THE CORRECT CONNECTOR IN-
SERTION.
BRAK SYS - 170
V85 TT