V85 TT
•
Insert the spring (10), making sure that
it is aligned correctly The end where
the spirals are more compressed
should be facing upwards
•
Insert the pre-load tube (11), making
sure that it is aligned correctly. The
narrower part must be inserted into the
spring.
•
Insert the upper plate (12) on the pre-
load pipe
•
After positioning the device (13) on the
pre-load pipe (11) and the plunger sup-
port shaft (14), with the assistance of a
second operator, raise the plunger so
that it is possible to insert the plate (15)
under the cap locking nut.
Specific tooling
020888Y Clamp for pre-load pipe
AP8140150 Bored shaft for bleeding plunger
air
AP8140148 Plunger-spacer separator plate
Suspensions
SUSP - 101