Installation; Mounting The Modules On A Din Rail - Mitsubishi Electric NZ2GN2B1-32D User Manual

6.4

Installation

Mounting the modules on a DIN rail

Installation procedure
Do not slide modules from the edge of the DIN rail when mounting them. The I/O module may be damaged.
Removal procedure
Remove the I/O module from the DIN rail by reversing the above procedure.
Applicable DIN rail models
Use the following DIN rails that are compliant with JIS C 2812 and IEC 60715.
• TH35-7.5Fe
• TH35-7.5Al
Interval between DIN rail mounting screws
Tighten the screws at intervals of 200mm or less.
6 INSTALLATION AND WIRING
64
6.4 Installation
1.
Hang the upper tabs of the I/O module on a DIN rail.
2.
Push in the DIN rail hooks of the I/O module until they
click.
1.
While pushing down the DIN rail hook with a flathead
screwdriver, remove the I/O module from the DIN rail by
pulling its lower part toward you.