Download  Print this page

Mitsubishi Electric NZ2GN2B1-32D User Manual Page 22

Programmable controller cc-link ie tsn remote i/o module.
Hide thumbs


NZ2GN2B1-32D DC input module
Station type
Authentication Class
Number of input points
Rated input voltage
Rated input current
Maximum number of simultaneous input points
ON voltage/ON current
OFF voltage/OFF current
Input resistance
Input response time
Withstand voltage
Insulation resistance
Noise immunity
Protection degree
Wiring method for common
External interface
Communication part
Module power supply part
I/O part
Applicable wire size
For power supply
For I/O
Applicable solderless
Terminal block for module
power supply and FG
Terminal block for input
Cyclic transmission
RX/RY points
RWr/RWw points
Module power supply
*1 If the input response time is set to "0ms", the actual input response time is 80μs at OFF → ON, and 160μs at ON → OFF.
*2 It is the noise immunity of when the input response time setting value is other than "0ms". Note that the module is easily affected by
noise if "0ms" is set.
*3 Use bar solderless terminals for wiring.
*4 Only one wire can be inserted into a wire insertion opening for the terminal block for module power supply and FG. Multiple wires cannot
be connected to a terminal. Connecting two or more wires may cause a poor contact.
3.3 Performance Specifications
Remote station
Authentication Class B
32 points
24VDC (ripple rate: 5% or less) (Allowable voltage range: 20.4 to 28.8VDC)
6.0mA TYP. (for 24VDC)
11VDC or more/4mA or more
5VDC or less/1.5mA or less
(Factory default: 1ms)
510VAC for 1 minute between all DC external terminals and ground
10MΩ or higher between all DC external terminals and ground (500VDC insulation resistance tester)
Noise voltage 500Vp-p, noise width 1μs, noise frequency 25 to 60Hz (DC type noise simulator
32 points/common (Common terminal: terminal number 33, 34) (1-wire, screw terminal block type)
Positive common/negative common shared type
RJ45 connector
Terminal block for module power supply and FG (2-piece spring clamp terminal block)
34-point two-piece terminal block
Tightening torque range for terminal screw (M3 × 5.2 screw): 0.43 to 0.57N⋅m
Tightening torque range for terminal block mounting screw (M3.5 screw): 0.68 to 0.92N⋅m
Stranded wire: 0.3 to 1.5 (22 to 16 AWG), terminal slot size: 2.4mm × 1.5mm
Stranded wire: 0.3 to 2.0 (22 to 14 AWG)
Page 65 Applicable solderless terminal
Page 72 Applicable solderless terminal
32 points
4 points
24VDC (ripple rate: 5% or less) (Allowable voltage range: 20.4 to 28.8VDC)
110mA or less (24VDC, all points ON)


Table of Contents

   Related Manuals for Mitsubishi Electric NZ2GN2B1-32D

Comments to this Manuals

Symbols: 0
Latest comments: