Installation Environment And Installation Position; Installation Environment; Installation Position - Mitsubishi Electric NZ2GF-CCB User Manual

Cc-link ie field network-cc-link bridge module

Table of Contents

6.2

Installation Environment and Installation Position

6.2.1

(1) Installation location

Do not install the bridge module to the place where:

• Ambient temperature is outside the range of 0 to 55;

• Ambient humidity is outside the range of 5 to 95% RH;

• Condensation occurs due to rapid temperature change;

• Corrosive gas or combustible gas is present;

• Conductive powder such as dust and iron powder, oil mist, salinity, or organic solvent is filled;

• The bridge module is exposed to direct sunlight;

• A strong electric field or strong magnetic field is generated; and

• The bridge module is subject to vibration and shock.

(2) Installation surface

Install the bridge module on a flat surface. When the installation surface is uneven, excessive force is applied to

the printed-circuit board, causing a failure.

6.2.2

When installing the bridge module in a control panel, provide clearance of 60mm or longer between the module and

the sides of the control panel or neighboring modules to ensure good ventilation and to facilitate a module change.

60mm

or longer

60mm

or longer

60mm

or longer

CHAPTER 6 INSTALLATION AND WIRING

60mm

or longer

Table of Contents