After Installation - Siemens SIMOTION C Operating Instructions Manual

Configuring and installing
4.3 Installing
4.3.3

After installation

Inserting the key (C230-2)
Once the C230-2 has been mounted on the mounting rail, you can insert the key in the
STOP or STOPU position on the C230-2.
Figure 4-7
Assigning the slot numbers
After mounting, you can assign each module a slot number. This eases the assignment of
the modules to the configuration table in the
slot number assignment.
Table 4- 7
88
Inserting the key in the C230-2
Slot numbers for S7 modules and SIMOTION C
Slot no.
1
2
3
4
5
6
7
8
9
10
11
Engineering System
Module
Power supply (PS)
SIMOTION C
Reserved
1. I/O module
2. I/O module
3. I/O module
4. I/O module
5. I/O module
6. I/O module
7. I/O module
8. I/O module
. The table below shows the
Comments
-
-
-
To the right of SIMOTION C
-
-
-
-
-
-
-
SIMOTION C
Operating Instructions, 02/2012