Using With Gangway4; Gangway Controls - JLCooper Electronics TransportPro RS422 User Manual

Using with GangWay4

The TransportPro is able to remotely control the GangWay4.
To use the GangWay4 with the TransportPro, simply connect the TransportPro to
the rear panel controller port of the GangWay4 as shown below.
Connecting the GangWay4 to the TransportPro and 4 video

GangWay Controls

When GangWay Operation is enabled in the menu, the Machine Control buttons
and LEDs are repurposed to control the GangWay4 (Ports 1-16 only). In this case,
the functions of the buttons and LEDs are as follows:
Select Channel
Pressing this button enters the GangWay4 configuration mode. In this mode,
the Select Channel LED will illuminate and the VFD will show and the 1 - 4 LEDs
will show the GangWay4 routing.
Tally
Pressing this button allows you to select the port, which provides Tally
information (timecode, status) to the TransportPro. In this mode, the Tally LED
will illuminate and the 1 - 4 LEDs will show the GangWay4 Tally routing.
1 - 4
These numbered switches allow the user to enable a slave device connected to
the corresponding numbered port on the rear panel. This allows commands
from the controller port to be routed to the selected numbered port(s).
When the Set Tally button is not pressed,
A button illuminates when the port is selected for control.
A button is extinguished when the port is not selected for control.
Then the Set Tally button is pressed,
A button illuminates when the port is selected for Tally.
A button is extinguished when the port is not selected for Tally.
TransportPro RS422 User Manual
recorders
11