Commissioning; Parameterization With Wago-I/O-Check - WAGO 750-496 Manual

44

Commissioning

Pos : 35 /All e Seri en (Allgemei ne Module)/Ü berschriften/Ebene 1/In Betri eb nehmen - Ü bersc hrift 1 @ 4\mod_1240901452750_21.doc x @ 31570 @ 1 @ 1
7 Commissioning
Pos : 36 /Serie 750 ( WAGO-I/O-SYST EM)/In Betrieb nehmen/Parametrier en mit WAGO- I/O-CH ECK/Parametrier en mit WAGO-I/O-CH ECK - Übersc hrift 2 @ 7\mod_1268645151531_21.doc x @ 52473 @ 2 @ 1
7.1

Parameterization with WAGO-I/O-CHECK

Pos : 37 /Serie 750 ( WAGO-I/O-SYST EM)/In Betrieb nehmen/Parametrier en mit WAGO- I/O-CH ECK/Konfigurier en und Parametrier en mit WAGO I/O-CHEC K 750- 0496 @ 22\mod_1426780105863_21.doc x @ 178226 @ 3444566554555555444 @ 1
</dg_ The WAGO-I/O-CHECK software from WAGO Kontakttechnik GmbH & Co.
KG can be used to conveniently and completely configure and parameterize the
I/O module. You have the following options.
• Graphical display of bus nodes
• Display of the measured values
• Settings for the application
• Configuration of the I/O module operating modes
• Parameterization of module, channel and scaling settings
• Calibration of channels and adjustment of analog inputs
• Monitoring
WAGO-I/O-CHECK
You can obtain the WAGO-I/O-CHECK software on a CD under Item No. 759-
302. This CD contains all the application program files and an explanation. You
can find a description at the internet page at
Save all your settings before you begin parameterization!
To be on the safe side you should always save all of your current settings in a
parameter file before you begin parameterization. This enables you to always use
the original values, should any parameters you are defining not be correct.
WAGO-I/O-SYSTEM 750
750-496 8AI 0/4-20mA S.E.
http://www.wago.com
Manual
Version 1.2.0