DEUTSCHMANN AUTOMATION UNIGATE CL-Fast Ethernet Instruction Manual page 40

Ethernet
The program is started. After initialization, the program displays a selection box with the name
"Adapter IP", that shows the Ethernet network adapter, located on the computer, with the base
addresses of the respective network.
For the scan mode you first select the desired adapter. Subsequently a search process is
initiated by pressing the scan button. The big window of the UNIGATE
®
ATE devices found in the network with MAC address, IP address, type and software revision.
From the list of displayed UNIGATE
be configured with a new IP address. With the flash function you can make sure wether you have
selected the desired UNIGATE
®
ted UNIGATE device flashes red for 5 seconds.
Via the Set-IP-button, and if the correct UNIGATE
device with the address shown in the "IP-address" window.
If you want to permanently save the address in the UNIGATE
"set_perm".
After turning the UNIGATE
transferred correctly with another scan.
40 UNIGATE
®
devices you now select the device that, for example, should
®
. After pressing the flash button the bus state LED on the selec-
®
off and then back on, you can check if the new address has been
Fieldbus Gateway UNIGATE
®
Deutschmann Automation GmbH & Co. KG
®
-Scan displays the UNIG-
®
device is selected, you can configure the
®
you have to check the field
CL - Fast Ethernet V. 2.6
®
21.6.18