JA
DIAGNOSIS AND TESTING (Continued)
Fig. 2 Power Seat Switch
VOLTAGE
The following test will determine whether or not
voltage is continuous through the body harness to
the switch.
(1) Remove power seat switch from mounting posi-
tion and disconnect switch from wiring harness.
(2) Using a voltmeter, connect the ground lead to
Pin 5 of the switch harness connector. Connect the
positive lead to Pin 1. If battery voltage is seen, the
ground and B+ circuit is OK. If no voltage is seen,
check the circuit breaker and repair as necessary.
REMOVAL AND INSTALLATION
FRONT SEAT ASSEMBLY
Refer to Group 23, Body for Front Seat Removal
and Installation.
POWER FRONT SEAT ADJUSTER
Before the seat adjuster can be serviced, the front
seat assembly must be removed from the vehicle.
Refer to Group 23, Body for Front Seat Removal and
Installation.
REMOVAL
Once the front seat is removed, lay it on a clean
surface upside down to expose the underside of the
seat assembly.
(1) Remove the four screws retaining the left and
right seat cushion side shields.
(2) Disconnect the power seat switch connectors
from the seat cushion side shield and remove side
shield.
(3) Remove the four bolts retaining the power seat
adjuster to the seat assembly and remove.
INSTALLATION
For installation, reverse the above procedures.
POWER SEAT SWITCH
REMOVAL
(1) Remove left cushion side shield (Fig. 3).
Fig. 3 Switch Removal
(2) Disconnect wiring from switch.
(3) Remove the seat and recliner switch knobs.
(4) Remove attaching screws and switch from
bezel.
INSTALLATION
For installation, reverse the above procedure.
POWER SEATS
8R - 3