Chrysler Stratus RHD 1999 Electronic Service Manual page 450

JA
REMOVAL AND INSTALLATION (Continued)
WINDOW SWITCH
MASTER SWITCH
REMOVAL
(1) Remove driver's door trim panel, refer to Group
23, Body for removal procedures.
(2) Remove three mounting screws.
(3) Remove switch and disconnect wire connector.
INSTALLATION
For installation, reverse the above procedures.
PASSENGER SWITCH
REMOVAL
(1) Remove passenger door trim panel, refer to
Group 23 Body, for removal procedures.
(2) Disconnect switch wire connector.
(3) Using a trim stick (special tool #C-4755), gently
pry out switch from bezel being careful not to dam-
age bezel. First, insert the trim stick into the switch
pocket in the flush side to release that side from the
pocket. Use only enough force on the trim stick to
permit the switch to be released from the pocket, and
avoid twisting the stick to prevent damage to the
switch or plastic pocket.
NOTE: The connector is flush with one side of the
switch housing (Fig. 4).
Fig. 4 Passenger Power Window Switch
(4) After the flush side is released, release the
non-flush side with similar care.
NOTE: Releasing the non-flush side first will make
the flush side less accessible requiring extra force
to remove.
INSTALLATION
For installation, reverse the above procedures.
POWER WINDOWS 8S - 3