Chrysler Stratus RHD 1999 Electronic Service Manual page 951

14 - 22 FUEL SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 33 Fuel Filler Hose Clamp
Fig. 34 Evap Components
(14) Remove tank from vehicle. Slide tank forward
during removal to allow fill neck to clear suspension
cross-member.
INSTALLATION
(1) Position fuel tank on transmission jack.
(2) Raise tank into position.
(3) Connect vapor line to rollover valve.
(4) Install EVAP hoses and lines.
(5) Connect fuel pump electrical connector.
(6) Install pump module harness grommet into
body.
(7) Connect chassis fuel tube to fuel filter. Refer to
Quick Connect Fittings in this section.
(8) Connect fuel fill tube to tank inlet. Tighten
hose clamp to 3.5 N·m (31 in. lbs.) torque.
Fig. 35 Fuel Tank Removal
(9) Position fuel filter and fuel tank straps. Install
the front bolts first and then the rear bolts. Tighten
fuel tank strap bolts to 23 N·m (250 in. lbs.) torque.
Remove transmission jack. Ensure straps are not
twisted or bent.
(10) Lower vehicle.
(11) Connect fuel pump module connector, inside of
vehicle. Install rear seat cushion.
(12) Fill fuel tank, install filler cap, and connect
battery cable.
CAUTION: When using the ASD Fuel System Test,
the ASD relay remains energized for either 7 min-
utes, until the test is stopped, or until the ignition
switch is turned to the Off position.
(13) Use the DRB scan tool ASD Fuel System Test
to pressurize the fuel system. Check for leaks.
FUEL FILLER NECK
REMOVAL
(1) Loosen fuel filler tube cap.
(2) Remove fuel filler neck screws (Fig. 36).
(3) Disconnect Ground strap from body.
(4) Disconnect fuel filler tube hose from fuel tank
neck. Remove fuel filler tube assembly.
INSTALLATION
(1) Reverse for installation.
JA