Removal And Installation; Body Control Module (Bcm); Headlamp Switch; Junction Block (Jb) - Chrysler Stratus RHD 1999 Electronic Service Manual

JA
DIAGNOSIS AND TESTING (Continued)
(1) Check all door jamb switches.
(2) Use DRB lll scan tool to perform CCD diag-
nostics on Body Control Module for battery and igni-
tion switch input
(3) Inspect Body Control Module connectors and
wires for proper connection.
(4) Remove Body Control Module from Junction
Block. Check for battery voltage at terminal JB-12
and ignition feed at terminal JB-6 of Body Control
Module. Refer to Group 8W, Wiring Diagrams for the
location of the terminals.
(5) If voltage not OK, repair as necessary.
NO TONE WHEN HEADLAMPS ARE ON, IGNITION
SWITCH IS OFF AND DRIVER'S DOOR IS OPEN.
(1) Check left door jamb switch for good ground
when driver's door is open.
(2) Use DRB lll scan tool to perform CCD diag-
nostics on Body Control Module for battery, ignition
switch input, headlamp and driver's door input and
Chime Output Test.
(3) Check headlamp switch.
(4) Inspect Body Control Module connectors and
wires for proper connection.
(5) Remove Body Control Module from Junction
Block. Check for battery voltage at terminal JB-12
and ignition feed at terminal JB-6 of Body Control
Module. Refer to Group 8W, Wiring Diagrams for ter-
minal location.
(6) If voltage not OK, repair as necessary.
NO TONE WHEN IGNITION KEY IS LEFT IN
IGNITION SWITCH AND IT IS IN THE OFF
POSITION WITH DRIVER'S DOOR IS OPEN
(1) Check left door jamb switch for good ground
when drivers door is open.
(2) Use DRB lll scan tool to perform CCD diag-
nostics on Body Control Module for battery, ignition
switch input, key-in-switch and driver's door input
and Chime Output Test.
(3) Check key-in switch.
(4) Inspect Body Control Module connectors and
wires for proper connection.
CHIME WARNING / REMINDER SYSTEM
(5) Remove Body Control Module from Junction
Block. Check for battery voltage at terminal JB-12
and ignition feed at terminal JB-6 of Body Control
Module. Refer to Group 8W, Wiring Diagrams for ter-
minal location.
(6) If voltage not OK, repair as necessary.
CHIMES CONTINUE WHEN HEADLAMPS ARE
TURNED OFF AND/OR KEY IS REMOVED FROM
IGNITION
(1) Use DRB lll scan tool to perform CCD diag-
nostics on Body Control Module for headlamp or key-
in-ignition inputs.
(2) Check wiring for a grounded condition between
key-in switch and Body Control Module. Check head-
lamp switch to Body Control Module wiring for short
to battery.
(3) Inspect Body Control Module connectors and
wires for proper connection.

REMOVAL AND INSTALLATION

BODY CONTROL MODULE (BCM)

Refer to Group 8E, Instrument Panel and Systems
for Removal and Installation.

HEADLAMP SWITCH

Refer to Group 8E, Instrument Panel and Systems.

JUNCTION BLOCK (JB)

Refer to Group 8O, Power Distribution Systems for
Removal and Installation.

KEY-IN SWITCH

The Key-in switch is built into the ignition switch
assembly. Should the Key-in switch require service,
the ignition switch assembly must be replaced. Refer
to Group 8D, Ignition System for service procedures.

SEAT BELT BUCKLE

Refer to Group 23, Body for service procedures.
8U - 3