Chrysler Stratus RHD 1999 Electronic Service Manual page 792

JA
REMOVAL AND INSTALLATION (Continued)
Fig. 52 Crankshaft Damper—Removal
(3) Raise vehicle on hoist and install right inner
splash shield.
Fig. 53 Crankshaft Damper—Installation
TIMING BELT COVER
REMOVAL
(1) Disconnect negative
jumper terminal.
(2) Remove accessory drive belts. Refer to Group 7,
Cooling System for procedure.
(3) Raise vehicle on a hoist and remove right inner
splash shield (Fig. 51).
(4) Remove crankshaft vibration damper. Refer to
procedure in this section for removal.
(5) Lower vehicle and place a jack under engine.
(6) Remove right engine mount. Refer to procedure
in this section.
(7) Remove generator and bracket (Fig. 54). Refer
to Group 8C, Charging System for specific proce-
dures.
(8) Remove right engine mount bracket (Fig. 55).
(9) Remove front timing belt cover (Fig. 56).
cable from auxiliary
Fig. 54 Generator and Brackets
Fig. 55 Right Engine Mount Bracket
INSTALLATION
(1) Install front timing cover.
(2) Install engine mount bracket.
(3) Install right engine mount. Refer to procedure
in this section for installation.
(4) Remove jack from under engine.
(5) Install generator bracket (Fig. 54). Tighten
mounting bolts to 61 N·m (45 ft. lbs.).
(6) Install generator (Fig. 54). Refer to Group 8C,
Charging System for procedures.
(7) Install crankshaft vibration damper. Refer to
procedure in this section for installation.
(8) Install accessory drive belts. Refer to Group 7,
Cooling System Accessory Drive section for proce-
dure.
(9) Raise vehicle on hoist and install right inner
splash shield.
(10) Connect negative cable.
2.0L SOHC ENGINE 9 - 37