Chrysler Stratus RHD 1999 Electronic Service Manual page 76

JA
REMOVAL AND INSTALLATION (Continued)
(6) Remove disc brake caliper assembly from steer-
ing knuckle. Caliper is removed by first lifting bot-
tom of caliper away from steering knuckle, and then
removing top of caliper out from under steering
knuckle (Fig. 4).
Fig. 4 Removing Disc Brake Caliper
(7) Support brake caliper/adapter assembly using a
wire hook (Fig. 5). Do not support assembly by
the brake flex hose.
Fig. 5 Correctly Supported Brake Caliper
(8) Remove braking disc from front hub.
(9) Remove nut attaching outer tie rod end to
steering knuckle. Remove nut from tie rod end by
holding tie rod end stud with a 11/32 socket and
loosen and remove nut (Fig. 6).
(10) Remove the tie rod end stud from steering
knuckle arm, using remover, Special Tool MB-990635
(Fig. 7).
(11) If equipped with antilock brakes, remove the
speed sensor cable routing bracket from the steering
knuckle (Fig. 8).
DIFFERENTIAL AND DRIVELINE
Fig. 6 Removing Tie Rod End Attaching Nut
Fig. 7 Tie Rod End Removal from Steering Knuckle
Fig. 8 Wheel Speed Sensor Cable Routing Bracket
3 - 3