Chrysler Stratus RHD 1999 Electronic Service Manual page 195

5 - 90 BRAKES
REMOVAL AND INSTALLATION (Continued)
Fig. 34 ICU Remove And Install
Fig. 35 Torquing Primary And Secondary Brake
Tube Nut
Fig. 36 Torquing Chassis Brake Tube Nuts
(14) Lower vehicle.
(15) Remove brake pedal holding tool.
(16) Install the remote ground cable onto the
ground stud located on left shock tower (Fig. 20).
Install the remote ground cable attaching nut and
tighten to a torque of 28 N·m (250 in. lbs.).
(17) Bleed the base brakes and the ABS brakes
hydraulic system. Refer to the Bleeding ABS System
in this section of the manual for the proper bleeding
procedure.
(18) Road test vehicle to ensure proper operation
of the base and ABS systems.
PROPORTIONING VALVE
NOTE: Before proceeding, review SERVICE WARN-
INGS AND CAUTIONS at the beginning of this
REMOVAL AND INSTALLATION section.
CAUTION: Proportioning valves should never be
disassembled.
This procedure is for removal and installation of
one of the two proportioning valves mounted on this
vehicle equipped with ABS.
REMOVAL
(1) Remove chassis brake (Fig. 37) from propor-
tioning valve controlling the rear wheel of the vehicle
which has premature wheel skid.
Fig. 37 Proportioning Valve Location
CAUTION: When removing
from flex hose place wrench on proportioning valve
(Fig. 38) not adapter fitting. The adapter fitting (Fig.
38) is not to be removed from the proportioning
valve.
(2) Remove proportioning valve from brake flex
hose (Fig. 38).
JA
proportioning valve