Door Mounted Speaker - Chrysler Stratus RHD 1999 Electronic Service Manual

8F - 14 AUDIO SYSTEMS
DIAGNOSIS AND TESTING (Continued)
Fig. 2 Power Antenna Assembly
(I) Check the connection of the DIN cable to
the CD changer and radio.
(II) If OK, then check the DIN cable at the CD
changer side.
(III) Make sure the DIN cable is connected to
the radio and radio is turned ON and operating
properly. Check for battery voltage at Pins 6 and
7 using Pin 8 for ground.
(IV) If OK, then replace CD changer.
(V) If not OK, then remove DIN cable from
radio and changer. Check DIN cable for continu-
ity from connector to connector, using a ohmme-
ter on each Pin.
(VI) If the DIN cable OK, then replace the
radio.
DIN Cable Connector
REMOVAL AND INSTALLATION

DOOR MOUNTED SPEAKER

CAUTION: Do not operate the radio with speaker
leads detached. Damage to the output devices may
result.
DIN CABLE PIN-OUTS
PIN 1 DATA BUS (-)
PIN 2 AUDIO GRD
PIN 3 DATA BUS (+)
PIN 4 AUDIO IN (R)
ERROR MESSAGES
DISPLAY EXPLANATION
nocd No disc or discs
in magazine
- - - - No magazine in
player
Err HOT Player
overheating
Err EE Communication
EE problem
Err E-01 Deadlock
problem
Err E-02 Disc eject
problem
Err E-06 Elevator
problem
Err E-07 Magazine eject
problem
Err PLAY Discs cannot
play
REMOVAL
(1) Remove window crank handle if equipped.
Carefully, pry speaker grille away from door trim
panel (Fig. 3).
(2) Remove three speaker retaining screws.
(3) Pull speaker away from door and disconnect
wiring.
INSTALLATION
For installation, reverse the above procedures.
Ensure speaker is in the proper position
JA
PIN 5 AUDIO IN
(L)
PIN 6 BATTERY
PIN 7 IGNITION
PIN 8 GROUND
WHAT TO DO
Load discs in
magazine
Load magazine in
player
Allow to cool down
Turn ignition OFF to
reset, check cable
connection. If OK,
replace changer.
Replace changer.
Replace changer.
Replace Changer.
Check that the
magazine is OK. If
OK, replace changer.
Check disc loading, or
try another disc. If OK,
replace changer.