Chrysler Stratus RHD 1999 Electronic Service Manual page 385

8L - 10 LAMPS
REMOVAL AND INSTALLATION (Continued)
(5) Rotate socket counterclockwise one quarter
turn.
(6) Pull socket from back of lamp (Fig. 7).
(7) Pull bulb from socket.
Fig. 7 Tail, Stop, and Turn Signal Lamp Bulb
INSTALLATION
Reverse the preceding operation.
BACK-UP LAMP BULB
REMOVAL
(1) Release decklid latch and open decklid.
(2) Remove wing-nuts attaching tail lamp to rear
closure panel.
(3) Remove lamp from opening in quarter panel.
(4) Disconnect wire connector from back of tail
lamp.
(5) Rotate socket counterclockwise one quarter
turn.
(6) Pull socket from back of lamp (Fig. 8).
(7) Pull bulb from socket.
Fig. 8 Back – Up Lamp Bulb
INSTALLATION
Reverse the preceding operation.
LICENSE PLATE LAMP BULB
REMOVAL
(1) Remove screws attaching license plate lamp to
rear bumper fascia.
(2) Remove license plate lamp from rear fascia.
(3) Rotate socket counterclockwise one quarter
turn.
(4) Pull socket from back of lamp.
(5) Pull bulb from socket.
Fig. 9 License Plate Lamp Bulb
INSTALLATION
Reverse the preceding operation.
DOME LAMP BULB
REMOVAL
(1) Remove lamp lens from lamp assembly by
inserting a flat bladed pry tool in the slot provided in
the bezel.
(2) Separate lamp lens from lamp assembly.
(3) Pull dome lamp bulb from socket.
INSTALLATION
(1) Push dome lamp bulb into socket.
(2) Install lamp lens by first inserting the two tabs
located opposite the lamp switch and then pushing
upward on lens to engage remainder of tabs.
FRONT READING LAMP BULB
REMOVAL
(1) Remove front reading lamp from headlining.
Do not remove wire connector from lamp assembly.
JA