Chrysler Stratus RHD 1999 Electronic Service Manual page 159

5 - 54 BRAKES
REMOVAL AND INSTALLATION (Continued)
Fig. 156 Hub/Bearing Assembly Retaining Nut
Fig. 157 Park Brake Cable At Actuating Lever
from brake support plate using a 1/2 in. wrench as
shown in (Fig. 158) to compress locking tabs on park
brake cable retainer.
Fig. 158 Park Brake Cable Removal From Brake
Support Plate
(23) Raise vehicle.
NOTE: The park brake cable routing and routing
brackets are different on the right and left side of
the vehicle.
(24) Remove the 2 routing brackets attaching the
right hand side (Fig. 159) or left hand side (Fig. 160)
park brake cable to the frame rail.
Fig. 159 Park Brake Cable Routing Brackets (Right
Fig. 160 Park Brake Cable Routing Brackets (Left
(25) Remove the park brake cable and sealing
grommet (Fig. 161) from the floor pan of the vehicle.
INSTALLATION
(1) Install parking brake cable into floor pan of
vehicle making sure sealing grommet (Fig. 161) is
installed in floor pan as far as possible to insure a
proper seal.
(2) Install park brake cable into the rear brake
support plate. Be sure locking tabs on cable retainer
Side)
Side)
JA