Wiper And Washer Systems; Headlamp Washers - Chrysler Stratus RHD 1999 Electronic Service Manual

JA

HEADLAMP WASHERS . . . . . . . . . . . . . . . . . . . . . 1

GENERAL INFORMATION
INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . 1
REMOVAL AND INSTALLATION
HEADLAMP WASHER NOZZLE . . . . . . . . . . . . . . 2
GENERAL INFORMATION
INTRODUCTION
Headlamp washers are available as a factory-in-
stalled option on this model. The headlamp washers
on this vehicle work in conjunction with the wind-
shield washers. The headlamp washers are enabled
with the headlamps "ON" and the windshield wash-
ers activated. With the windshield washers activated
the headlamp washers will spray for a preset amount
of time controlled by a relay.
The headlamp washer system utilizes a separate
pump that is attached to the windshield washer res-
ervoir. The headlamp washer pump feeds two nozzles
that are mounted in the front fascia of the vehicle.
These nozzles spray the headlamps when the system
is activated.
REMOVAL AND INSTALLATION
WINDSHIELD/HEADLAMP WASHER
RESERVOIR
Removal
(1) Disconnect the washer fluid hose at the in-line
connector at the top of the right shock tower.
(2) Remove the right headlamp assembly. Refer to
Group 8L, Lamps.
(3) Partially remove the inner fender well as
needed to gain access to the reservoir.

WIPER AND WASHER SYSTEMS

CONTENTS
page
HEADLAMP WASHERS
page
WIPER AND WASHER SYSTEMS
INDEX
HEADLAMP WASHER PUMP . . . . . . . . . . . . . . . . 2
WINDSHIELD/HEADLAMP WASHER
RESERVOIR . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
(4) Disconnect the windshield washer pump and
headlamp washer pump electrical connectors.
(5) Remove the headlamp washer relay from
bracket.
(6) Disconnect the headlamp washer pump hose.
(7) Remove the reservoir mounting bolts (Fig. 1).
(8) Slide the reservoir rearward and remove from
the vehicle.
Installation
(1) For installation, reverse the above procedures.
Fig. 1 Reservoir Removal
8K - 1
page