Chrysler Stratus RHD 1999 Electronic Service Manual page 173

5 - 68 BRAKES
ADJUSTMENTS (Continued)
Fig. 196 Gearshift Knob Removal
Fig. 197 Boot Removal
Fig. 198 Center Console Front Attaching Screws
(Automatic)
CAUTION: Discard output cable retaining clip after
removing it from park brake cable tension equalizer.
Retainer is not to be re-used, a new retainer is to be
Fig. 199 Center Console Front Attaching Screws
Fig. 200 Park Brake Lever Output Cable Adjustment
installed when attaching output cable to tension
equalizer.
(9) Using a screwdriver (Fig. 201) unlatch the park
brake output cable retainer. Then remove cable
retainer from park brake cable tension equalizer.
(10) Remove the park brake cable tension equal-
izer from the park brake lever output cable and the
rear park brake cables (Fig. 202).
CAUTION: A new cable tension equalizer must be
installed when adjusting park brake cable tension.
(11) Install a NEW park brake cable tension
equalizer on the park brake lever output cable and
rear park brake cables (Fig. 202).
(Manual)
Nut
JA