Automatic Shutdown Relay - Chrysler Stratus RHD 1999 Electronic Service Manual

8D - 16 IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Install coil pack on valve cover.
(2) Transfer spark plug cables to new coil pack.
The coil pack towers are numbered with the cylinder
identification. Be sure the ignition cables snap onto
the towers.
Fig. 36 Electronic Ignition Coil Pack—2.0L
Fig. 37 Electronic Ignition Coil Pack—2.4L
IGNITION COIL—2.5L
The ignition coil is located in the distributor hous-
ing (Fig. 38).
If ignition coil is defective, replace distributor
assembly. Refer to Distributor Service.

AUTOMATIC SHUTDOWN RELAY

The relay is located in the Power Distribution Cen-
ter (PDC) (Fig. 39). The PDC is located in the engine
compartment. For the location of the relay within the
PDC, refer to the PDC cover for location. Check elec-
trical terminals for corrosion and repair as necessary.
CAMSHAFT POSITION SENSOR—SOHC
The camshaft position sensor is mounted to the
rear of the cylinder head (Fig. 40).
Fig. 38 Ignition Coil
Fig. 39 Power Distribution Center (PDC)
Fig. 40 Camshaft Position Sensor Location—SOHC
JA