Chrysler Stratus RHD 1999 Electronic Service Manual page 878

JA
REMOVAL AND INSTALLATION (Continued)
(20) Install oil filter. Fill engine crankcase with
proper oil to correct level.
(21) Evacuate and charge air conditioning system.
Refer to Group 24, Heating and Air Conditioning for
procedures.
(22) Start engine and run until operating temper-
ature is reached.
(23) Adjust transaxle linkage, if necessary.
INTAKE MANIFOLD/PLENUM
REMOVAL
(1) Disconnect negative
jumper terminal (Fig. 29).
WARNING: RELEASE FUEL SYSTEM PRESSURE
BEFORE SERVICING FUEL SYSTEM COMPONENTS.
SERVICE VEHICLES IN WELL VENTILATED AREAS
AND AVOID IGNITION SOURCES. NEVER SMOKE
WHILE SERVICING THE VEHICLE.
(2) Release fuel system pressure. Refer to Fuel
System Pressure Release procedure in this section.
WARNING: WRAP SHOP TOWELS AROUND HOSE
TO CATCH ANY GASOLINE SPILLAGE.
Fig. 28 Intake and Exhaust Manifolds—2.5L Engine
cable from auxiliary
(3) Disconnect fuel supply tube from rail. Refer to
Group 14, Fuel System for procedure.
(4) Unplug connectors from MAP and intake air
temperature sensors (Fig. 31).
(5) Remove plenum support bracket bolt located
rearward of MAP sensor (Fig. 31).
(6) Remove bolt holding air inlet resonator to
intake manifold (Fig. 30).
(7) Loosen throttle body air inlet hose clamp.
Fig. 29 Auxiliary Jumper Terminal
2.5L ENGINE 9 - 123