9 - 42
2.0L SOHC ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 71 Crankshaft Damper—Installation
TIMING BELT—WITH MECHANICAL
TENSIONER
CHECKING BELT TIMING—COVER INSTALLED
• Remove number one spark plug.
• Using a dial indicator, set number one cylinder
to TDC on the compression stroke.
• Remove the access plug from the outer timing
belt cover (Fig. 72).
• Check the timing mark on the camshaft
sprocket, it should align with the arrow on the rear
belt cover (Fig. 73).
REMOVAL—TIMING BELT
(1) Disconnect
jumper terminal.
(2) Remove accessory drive belts. Refer to Group 7,
Cooling System for procedure.
(3) Raise vehicle on a hoist and remove right inner
splash shield (Fig. 74).
(4) Remove right front wheel.
Fig. 72 Timing Belt System
Fig. 73 Camshaft Timing Marks
negative
cable
JA
from
auxiliary