Clutch Pedal Position Switch; Specifications; Nv T350 (A-578) Clutch Tightening; Reference - Chrysler Stratus RHD 1999 Electronic Service Manual

JA
ADJUSTMENTS (Continued)
Fig. 8 Clutch Cable Routing
the clutch cable housing toward the dash panel. With
less than 25 lbs. of effort the cable housing should
move 30-50mm. This indicates proper adjuster mech-
anism function. If the cable does not adjust, deter-
mine if the mechanism is properly seated on the
bracket.
(2) If the adjust mechanism functions properly,
guide the cable through the slot in the transaxle
housing. Connect cable to release lever, seating the
cupped washer securely on lever tangs.
(3) Pull back on clutch cable housing and insert
into transaxle housing (Fig. 9).
(4) Reinstall cable inspection cover and air cleaner
assembly. Check clutch pedal position switch opera-
tion.

CLUTCH PEDAL POSITION SWITCH

The clutch pedal position switch is mounted to a
bracket located behind the clutch pedal. The switch
is held in place by four plastic wing tabs.
The clutch pedal position switch IS NOT adjust-
able. The pedal blade contacts the switch in the down
position (Fig. 10).
Fig. 9 Cable at Transaxle
Fig. 10 Clutch Pedal Position Switch and
Components

SPECIFICATIONS

NV T350 (A-578) CLUTCH TIGHTENING

REFERENCE

DESCRIPTION
Drive Plate To Clutch Bolts . . . . 75 N·m (55 ft. lbs.)
Drive Plate To Crankshaft Bolts . . . . . . . . . 95 N·m
Clutch Pedal Pivot Shaft Nut . . . 41 N·m (30 ft. lbs.)
CLUTCH 6 - 9
TORQUE
(70 ft. lbs.)