Chrysler Stratus RHD 1999 Electronic Service Manual page 390

JA
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Position lamp/switch assembly from vehicle.
(2) Engage wire connector to assembly.
(3) Push upward on lamp/switch assembly to
engage tabs holding assembly to instrument panel.
FLOOR TRANSMISSION RANGE INDICATOR
LAMP
REMOVAL
(1) Remove gear shift knob. Refer to Group 21,
Transmissions, for procedure.
(2) Using a plastic trim stick, Special Tool C-4755,
disengage the forward or rear edge of transmission
range indicator bezel from floor console.
(3) Pull upward carefully on transmission range
indicator bezel and disengage tabs from rear floor
console bezel.
(4) Disconnect wire connector to lamp assembly.
(5) Remove transmission range indicator bezel and
lamp assembly from vehicle.
INSTALLATION
(1) Position transmission range indicator bezel and
lamp assembly to vehicle.
(2) Connect wire connector to lamp assembly.
(3) Engage tabs on transmission range indicator
bezel to slots in rear floor console bezel.
(4) Push downward on transmission range indica-
tor bezel to engage to bezel to floor console.
SPECIAL TOOLS
LAMP SERVICE
Trim Stick C-4755
LAMPS 8L - 15