Removal And Installation; Multi-Function Switch; Washer Nozzle - Chrysler Stratus RHD 1999 Electronic Service Manual

JA
DIAGNOSIS AND TESTING (Continued)
CONDITION
MOTOR STOPS IN ANY
POSITION WHEN THE
SWITCH IS TURNED OFF
MOTOR WILL NOT STOP
WHEN SWITCH IS
TURNED OFF
WIPER BLADES SLAP
AGAINST COWL SCREEN
OR WINDOW MOLDINGS
BLADES CHATTER
WIPER KNOCK AT
REVERSAL
WIPER MOTOR WILL
NOT RUN

REMOVAL AND INSTALLATION

MULTI-FUNCTION SWITCH

REMOVAL
(1) Disconnect battery negative cable.
(2) Remove the upper steering column cover. Refer
to steering column cover removal procedures below.
(3) Remove multi-function switch mounting screws
(Fig. 8).
(4) Disconnect wire connectors. Lift the switch
straight up to remove.
INSTALLATION
For installation, reverse the above procedures.
POSSIBLE CAUSES
1) OPEN PARK CIRCUIT.
1) FAULTY SWITCH.
2) FAULTY RELAY.
1) WIPER ARMS ARE
PARKED INCORRECTLY.
1) FOREIGN
SUBSTANCE SUCH AS
POLISH ON GLASS OR
BLADES.
2) ARMS TWISTED,
BLADE AT WRONG
ANGLE ON GLASS.
3) BLADE STRUCTURE
BENT.
4) BLADE ELEMENT HAS
PERMANENT SET.
1) LINKAGE BUSHINGS
WORN.
2) ARMATURE ENDPLAY
IN MOTOR.
1) BLOWN FUSE.
2) NEW FUSE BLOWS
AGAIN.
3) NEW FUSE BLOWS
AGAIN.
4) NO VOLTAGE AT
MOTOR.
5) POOR GROUND.
WINDSHIELD WIPERS AND WASHERS
CORRECTION
1) CHECK PARK SWITCH BY DISCONNECTING
WIRE CONNECTOR AND APPLY BATTERY
VOLTAGE TO PIN A. PLACE A JUMPER WIRE
FROM PIN B TO PIN C, THEN TO AN EXTERNAL
GROUND. REPLACE MOTOR IF IT DOES NOT
PARK.
1) CHECK SWITCH IN LOW, HIGH, AND
INTERMITTANT POSITION. REPLACE IF
NECESSARY.
PARK SWITCH MAY BE SHORTED TO GROUND.
) REPARK WIPER ARMS. REFER TO WIPER ARM
REPLACEMENT.
1) CLEAN GLASS AND BLADE ELEMENT WITH
NON-ABRASIVE CLEANER.
2) REPLACE ARM.
3) REPLACE BLADE.
4) REPLACE BLADE ELEMENT.
1) REPLACE WORN LINK. REFER TO WIPER
LINKAGE REMOVAL.
2) REPLACE WIPER MOTOR. REFER TO WIPER
MOTOR REPLACEMENT.
1) REPLACE FUSE, RUN SYSTEM.
2) CHECK FOR SHORT IN WIRING OR SWITCH.
3) REPLACE FUSE, REMOVE MOTOR
CONNECTOR, TURN SWITCH ON, FUSE DOES
NOT BLOW, REPLACE MOTOR.
4) CHECK SWITCH AND WIRING.
5) CLEAN GROUND WIRE CONNECTION FROM
CORROSION.
(1) Tighten multi-function switch to column retain-
ing screws to 2.3 N·m (20 in. lbs.) torque.
(2) Tighten steering column cover retaining screws
to 2 N·m (17 in. lbs.) torque.

WASHER NOZZLE

REMOVAL
To replace nozzle, disconnect washer fluid hose.
Using a needle nose pliers, squeeze together the lock-
ing tabs on the nozzle.
INSTALLATION
For installing make sure that both locking tabs are
securely snapped into position. Connect washer fluid
8K - 7