Chrysler Stratus RHD 1999 Electronic Service Manual page 787

9 - 32 2.0L SOHC ENGINE
REMOVAL AND INSTALLATION (Continued)
(7) Remove power brake vacuum hose from intake
manifold.
(8) Raise vehicle and remove exhaust pipe from
manifold.
(9) Remove power steering fluid reservoir and set
aside.
(10) Disconnect coil pack wiring connector and
remove coil pack and bracket from engine.
(11) Remove cylinder head cover.
(12) Remove cam sensor and fuel injectors wiring
connectors.
(13) Remove intake manifold. Refer to procedure
in this section.
(14) Remove timing belt and camshaft sprocket.
Refer to procedure outlined in this section.
(15) Remove rocker arm shaft assemblies.
(16) Remove cylinder head bolts.
NOTE: Inspect camshaft bearing journals for scor-
ing. Cylinder head must be flat within 0.1 mm (0.004
inch) (Fig. 40).
Cylinder Head and Valve Assembly
INSTALLATION
EXAMINING CYLINDER HEAD BOLTS
NOTE: The cylinder head bolts should be examined
BEFORE reuse. If the threads are necked down, the
bolts should be replaced (Fig. 41).
Fig. 40 Checking Cylinder Head Flatness
JA