Chrysler Stratus RHD 1999 Electronic Service Manual page 453

8T - 2 POWER MIRRORS
DIAGNOSIS AND TESTING (Continued)
MIRROR MOTOR
(1) Remove door trim panel. Refer to Group 23,
Body.
(2) Disconnect wire connector from the switch.
(3) Using two jumper wires, one connected to a 12
volt battery source, and the other connected to a good
body ground. Refer to the Mirror Test (Fig. 2) for
appropriate mirror response, using the mirror switch
wiring harness connector.
(4) If test results are not obtained as shown in the
(Fig. 2), check for open or shorted circuit, or replace
mirror assembly as necessary.
Fig. 2 Mirror Motor Test
MIRROR SWITCH
(1) Remove door trim panel. Refer to Group 23,
Body.
(2) Disconnect wire connector.
(3) Using an ohmmeter, test for continuity between
the terminals of the switch as shown in the Mirror
Switch Test (Fig. 3).
(4) If test results are not obtained as shown in the
(Fig. 3), replace the switch.
Fig. 3 Mirror Switch Test
REMOVAL AND INSTALLATION
MIRROR ASSEMBLY
REMOVAL
(1) For door trim panel and mirror removal, refer
to Group 23, Body.
(2) Disconnect mirror.
(3) Remove attaching nuts.
(4) Test operation of mirror before installing door
trim panel.
INSTALLATION
For installation, reverse the above procedures.
MIRROR SWITCH
REMOVAL
(1) Remove door trim panel. Refer to Group 23,
Body.
(2) Disconnect wire connector.
(3) Remove attaching screws.
INSTALLATION
For installation, reverse the above procedures.
JA