Chrysler Stratus RHD 1999 Electronic Service Manual page 134

JA
REMOVAL AND INSTALLATION (Continued)
Fig. 65 Ground Cable Attachment To Strut Tower
(2) Correctly isolate remote ground cable when ser-
vicing vehicle by installing the ground cable insulator
on the strut tower ground stud as shown (Fig. 66).
This will prevent accidental grounding of the
remote ground cable.
Fig. 66 Correctly Isolated Remote Ground Cable
(3) Remove the PCV hose (Fig. 67) from the air
chamber located on the front of the intake manifold.
Remove bolt (Fig. 67) attaching the air chamber to
the intake manifold. Then unlatch lid of air cleaner
from air cleaner housing and loosen clamp attaching
air inlet hose to throttle body (Fig. 67). Remove the
air cleaner lid, air inlet hose and air chamber (Fig.
67) as an assembly from the engine.
(4) Remove the throttle cable and if equipped the
speed control cable from the throttle body (Fig. 68).
Remove the vacuum hose (Fig. 68) from the throttle
body. Remove the wiring harness connectors from
AIS motor and the Throttle Position Sensor (Fig. 68)
on the throttle body. Then, remove the 4 bolts (Fig.
68) attaching the throttle body to the intake manifold
and remove it from intake manifold.
Fig. 67 Engine Air Intake System Components
Fig. 68 Throttle Body Attachment To Intake Manifold
(5) Without removing cables from bracket, remove
the throttle and speed control cable mounting
bracket (Fig. 68) from the intake manifold.
(6) Remove the EGR tube (Fig. 69) from the intake
manifold and EGR valve.
(7) If equipped, remove the vehicle's wiring har-
ness connector from the speed control servo. Remove
the 2 speed control servo mounting bracket to strut
tower attaching nuts (Fig. 70). Without removing
speed control cable from servo, move speed control
servo out of the way.
(8) Remove the primary and secondary brake
tubes (Fig. 71) and (Fig. 72) from the master cylinder
assembly.
(9) Remove the vehicle's wiring harness connector
from the master cylinder brake fluid level sensor
(Fig. 73).
(10) Remove the 2 nuts (Fig. 74) attaching the
master cylinder assembly to the power brake vacuum
booster. Then remove the master cylinder assembly
from the power brake vacuum booster.
BRAKES 5 - 29