Section 6 Service Data For Body - Geely CK Series 2007 Workshop Manual

TABLE 5-1
Reshaping clearance between engine hood inner and
Clearance between LH/RH fender and hood
Clearance between LH/RH headlamp and hood
Clearance between front bumper and fender
Clearance between LH/RH headlamps and bumper,
Clearance between fender and LH/RH doors
Clearance between hood and bumper
Clearance between radiator grille and hood
Cowl ventilator cover hole and wiper shaft are
homocentric. Coaxial Degree
Clearance between door and side wall
Clearance between door and sill
Clearance between fuel fill port cover and side wall
Clearance between rear bumper and side wall plate
Clearance between Rear tail lamp and side wall plate
Clearance between windshield and drip channel
Glass is lower than drip channel
Clearance between glass and roof panel
Trunk lid folding edge, spot-welding interva l
Trunk lid inner plate flanging sides are higher than
Clearance between trunk lid and side wall plate
Clearance between trunk lid and rear combination
Clearance between trunk lid and bumper
Height difference of parts which is bilateral symmetry
on the outside body
Height of trunk lid limit block is proper. Height of the
sealing strip when the trunk lid is locked

Section 6 Service Data For Body

I. Service Data For Body (Table 5-1)
Service Data For Body
Content
outer plate
fender
outer plate
lamp
Service Data
3mm±0.5mm
5mm(0,-1mm)
7mm±0.5mm
≤ 1mm
5mm(0.-1mm)
5mm(0,-1mm) ， Height error ≤ 0.5mm
7mm±0.5mm
0.5mm
No more than 2mm
5mm(0,-1mm)
7mm±0.5mm
3mm±0.5mm
1mm±0.5mm
1mm±0.5mm
4—5mm
0.5—1mm
4.5—7mm and lower than 0.5—1mm
250—300mm Height of welding spot is no
more than 1mm
1—1.4m m
5mm(0,-1mm)
5mm(0,-1mm)
7mm±0.5mm
No more than 5mm
12mm
385