Inspect voltage between terminals
Standard:
Tester connection
3 - ground
Result and solution:
Abnormal
Repair or replace the harness or connector
Normal
Inspect the speed sensor output signal
3
Inspect the speed sensor output signal
Inspect voltage
Hold the front wheels up
Push the shift lever to NEUTRAL
Turn the ignition switch to ON
Slowly turn the front wheel, measure the voltage between terminal 1 and 2
Standard voltage is as follows:
Below 0.5V
Voltage changes alternately
Result and solution:
Normal
Repair or replace the harness or connector
Abnormal
replace the speed sensor
Condition
Turn the ignition switch to ON
Standard condition
7.5 – 9V
Turning Wheels
179