Geely CK Series 2007 Workshop Manual page 276

6
Try to disconnect at a location far away from the vehicle the connector of the wire harness for deployment
of the driver airbag assembly, connect them with the two terminals of the battery removed from the
vehicle and deploy the airbag (see the figure below).
Wire Harness
for Deployment
NOTICE
Make sure there is no man inside or near the vehicle and then carry out the operations.
After the driver airbag is deployed, the gas generator is of high temperature. Keep it for 30 minutes until it
gets cool for use.
If the driver airbag assembly cannot be deployed, discuss the problem with the local Geely service station.
7
The deployed driver airbag assembly shall be scrapped according to the scrapping procedures.
(3) Deploy outside the vehicle
NOTICE:
Keep the airbag over 6m away from a obstacle or person and deploy the airbag in an open flat area.
1
Disconnect the positive (+) and negative (-) terminal cables from the battery and remove the battery
from the vehicle.
NOTICE
Work must be started 60s after removal of the battery.
2
The airbag assembly shall be deployed according to the following procedures.
(4) Driver airbag assembly
1
Remove the driver airbag assembly from the vehicle.
NOTICE
When the connector is not connected, the terminals of the driver airbag assembly will be short circuited
automatically, preventing the airbag from being deployed unexpectedly. If the airbag is deployed unexpectedly,
the deployed surface should face up. It should be kept on a flat surface without any other items on it.
Vehicle Cover
269